Delrin Front Motor Mount for Mitsubishi / Mopar 24V 3.0L custom photo tumbler 20oz 275" dia x 2"

275" dia x 2"

the stock bushings can go bad and cause the roller to make increasing noise and eventually stop turning correctly

the stock mount is hollow and not very strong

In one configuration

Delrin Front Motor Mount for Mitsubishi / Mopar 24V 3.0L custom photo tumbler 20oz 275" dia x 2"This is a solid Delrin (Acetal) front motor mount for SOHC (24 valve) 3. 0L V6 equipped Mitsubishi Mopar vehicles. The mount is installed just as the stock mount. Once on the car, it looks stock, unless one knows what to look for. Installation is the same as replacing a stock mount. The stock mounts are a very weak piece. As shown below, the rubber insert is only held on by two small strips of rubber, allowing a lot of engine movement. With an engine